Hello Guest it is March 19, 2024, 02:20:06 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Jimildoo

Pages: 1
1
Mach3 under Vista / Mach3 and W7/32 spindle setup
« on: August 27, 2012, 11:14:58 PM »
I am having trouble with getting a spindle to run after replacing an XP PC with W7 32bit.
We have copied the xml and carefully reproduced all the Ports & Pins and Output Settings from the old pc to the new one.
Everything works except the spindle which crashes Mach3 when the start button is pressed, and gives an Error 9991.
We havent yet been able to get the output to flash in Diagnostics either.
Is there a place where error message numbers are explained, or can someone shed light?

Thanks

2
General Mach Discussion / Machining time or run time
« on: June 06, 2011, 01:52:12 AM »
Is there a way to get an estimate of the runtime for a file once it is loaded into Mach3?

Pages: 1