Hello Guest it is April 11, 2021, 08:08:00 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Figula

Pages: 1
1
General Mach Discussion / XYZ Can't Find switches Why!
« on: August 04, 2015, 07:58:46 PM »
Installed M3 in new XP Computer. All moving around fine. But can't we can't find our homing switches, also cant zero machine.  Switches all worked fine 7+years on last computer. 55 now and may be experiencing mental slippage. Please Help!
Figula  

2
General Mach Discussion / Climbing Z axis
« on: July 16, 2012, 04:50:28 PM »
 I'm having an issue with my Z axis slowly climbing out of my material as my relief file runs...it looks like it starts to climb around 50% of the file has run.
Question two I tried to run the file in reverse run to see if it happens in reverse but I can't seem to start the file in reverse. do I have to run the file all the way before I can reverse run? I attached the work after the scales of justice file ran
Thanks
Al

3
General Mach Discussion / Master and Slave not in sink?
« on: August 19, 2011, 05:36:12 PM »
Hi All, Why does my slave axis "A" end up .5" off Home after running a file or jogging around. And is it possible to set the steps of the slave. I'm a Joe's cnc 4x4 builder.
Al

4
General Mach Discussion / Job Loading Out in The Table... Why?
« on: February 07, 2011, 09:46:13 AM »
Why When I load a G-code it places it out in the table and not at homing?

Thanks
Figula

5
Hello all, "Requested home axis home switch is active.. please fix, Then Home.." Everything was homing, soft limits were set and I was routing jobs. And Loving it. All I did different was hooked up a shop-vac to catch dust and Homing stopped  and got the Requested Home Axis message. 

 I have XYZ run in one series to port 1 pin 10.

 Tested all switches & wire for continuity OK

 De-bounced to 2000

 Played with Config. & Reset Homing (Nothing)

 Motors are all lit in Diagnostics

 What can I try Next?

Al

Pages: 1