Hello Guest it is April 18, 2021, 10:47:52 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - gurasha

Pages: 1
1
General Mach Discussion / problem with parallel port
« on: November 12, 2010, 02:00:28 PM »
got a new computer wich has no integrated parallel port on it so I instaled paralell port card to connect computer to driver but.. mach3 has no control over card. the adress the it shows in properties is EC00. can u tell me what is the problem?

2
General Mach Discussion / NEWBEE problem with tb6560 and mach3
« on: November 07, 2010, 04:03:50 AM »
hello to everybody

just instaled mach3 and board tb6560. motors have no reaction on software. motors don't move. I allready  have run drivertest. can u give me any suggestions?

Pages: 1