1
General Mach Discussion / Delayed axis movement
« on: October 29, 2010, 08:17:59 PM »
Hello guys:
Newbie on board...I've done some searching of different discussions, but am unable to find any similar to my problem. I'm trouble shooting an issue with my homemade (leadscrew) router. I when I say newbie, I'm not kidding!!
When I use the arrow keys on my computer to move my X and Y axis, initially I get a delayed start of movement. I get a loud hum, then start of the axis. The delay is maybe 1/2 second or so. Then the axis runs normally. If I use the arrows fast (back and forth on either axis) there is no delay in change of direction. But if I wait 10-15 seconds, then start axis movement, I get that darned delay.
I'm trying to figure out if this is a software issue or hardware issue. Any suggestions would be appreciated.
Rod
Newbie on board...I've done some searching of different discussions, but am unable to find any similar to my problem. I'm trouble shooting an issue with my homemade (leadscrew) router. I when I say newbie, I'm not kidding!!
When I use the arrow keys on my computer to move my X and Y axis, initially I get a delayed start of movement. I get a loud hum, then start of the axis. The delay is maybe 1/2 second or so. Then the axis runs normally. If I use the arrows fast (back and forth on either axis) there is no delay in change of direction. But if I wait 10-15 seconds, then start axis movement, I get that darned delay.
I'm trying to figure out if this is a software issue or hardware issue. Any suggestions would be appreciated.
Rod