Hello Guest it is April 25, 2024, 08:39:44 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - fortyonethirty

Pages: 1
1
General Mach Discussion / How to set coordinates to specific values?
« on: July 15, 2015, 04:34:21 PM »
I have a plasma table with candcnc gear and I ran into a problem. I had to stop during a cut and restart the computer, but I was able to write down the x,y where the machine stopped. When I was ready to start again, I wanted to input the previous numbers, but I could not figure out how. I ended up zeroing it where it was, then i jogged to the negative of my coordinates and re-zeroed. This got the job done, but it would have been much easier to just type in the coordinates. How do I do that?

Pages: 1