Hello Guest it is January 20, 2020, 06:15:39 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - antennas4u

Pages: 1
1
General Mach Discussion / Mach3 Drivers
« on: June 11, 2016, 10:15:25 PM »
Hi,

My current driver is registering "Too fast", as per Mach3 Pulse Tester. Where do I find other drivers to download please.

Regards

Terry

2
Forum suggestions and report forum problems. / Z Axis
« on: July 25, 2015, 10:36:18 PM »
Hi,
I am unable to control my Z Axis. When I start the machine to cut a file the Z axis lowers, but wont stop, it wants to continue in a downward direction.
Has anybody got any ideas?

Regards
Terry
 :D

3
General Mach Discussion / Y axis
« on: August 08, 2013, 03:05:00 AM »
Hi,
My problem is when I turn my machine on and go into Mach3 the y axis hotkeys are always set up backwards. In other words the hot keys that I set them up to are now in reverse. How can I fix this problem?

Regards

Terry

4
General Mach Discussion / "External E Stop Requested" Fault
« on: May 08, 2012, 08:28:29 PM »
Hi I'm a Newbie,
I have a fault in my home bulit CNC router. My machine drops out every couple of minutes on a "External E Stop Requested" fault. I run Mach3. Can anybody help me rectify this problem PLEASE ?

Regards
Terry

5
General Mach Discussion / Mach3 EStop Fault
« on: May 08, 2012, 08:16:41 PM »
Hi I'm a newbie.
I have a problem with my home built CNC router bombing out very regularly on a "External E Stop Requested" fault. I'm using Mach3. Can anybody help me sort out this problem PLEASE !!! It stops the router about every couple of minutes.

Many Thanks

Terry

Pages: 1