1
General Mach Discussion / Computer Problems-Jittery steppers
« on: September 20, 2011, 02:29:15 AM »
Here's the problem-I just built a cnc plasma table, and got all the electronics hooked up. The motors move, but they run rough as hell. To narrow things down, I borrowed another computer, installed mach3 with the same settings, and the problems disappeared. The computer that runs rough is a Dell GX620 I got refurbished on Ebay. Everything on the computer seems fine, except when it comes to the motors. I even tried installing a parallel port card I had, and it didn't make any difference. Anybody seen anything like this? Or should I start looking for another computer?