Guest
Show Posts
1
Third party software and hardware support forums. / Gerber S/750 vinyl cutter plotter
« on: September 29, 2010, 04:24:24 AM »
this may be in the wrong forum but...
Hello i have a Gerber S/750 Vinyl cutter and pen plotter, and It shows only GSP and S/750 on it. now my questions are the following. Is it possible to use this plotter on a newer computer. Does it require a dongle. Can i reconfigure my own cable to allow connection to a newer computer. And what Free software can i use to operate this cutter plotter. Also will i need to replace the electronics to be able to use it on a newer computer? it has a 8. pin round plug connection that i believe goes directly into a computer. I have a powermac 5400/180 that came with it but no proprietary keyboard for that computer which is why i want to use a newer computer. I am also short on cash which is why i would like to use free software and free solutions if possible.
Hello i have a Gerber S/750 Vinyl cutter and pen plotter, and It shows only GSP and S/750 on it. now my questions are the following. Is it possible to use this plotter on a newer computer. Does it require a dongle. Can i reconfigure my own cable to allow connection to a newer computer. And what Free software can i use to operate this cutter plotter. Also will i need to replace the electronics to be able to use it on a newer computer? it has a 8. pin round plug connection that i believe goes directly into a computer. I have a powermac 5400/180 that came with it but no proprietary keyboard for that computer which is why i want to use a newer computer. I am also short on cash which is why i would like to use free software and free solutions if possible.