1
General Mach Discussion / Incorrect Router Repositioning
« on: June 28, 2011, 02:44:49 PM »
I'm new at this, so I hope someone can help. I'm trying to cut the simplest of cuts and can't imagine what is going wrong. The cuts are two concentric circles. Each cuts perfectly round and to size, but off center. A 3" circle inside a 5" circle winds up with one side of the 3" 1/4" from the 5". Cutting round and to size seems to say the motor travel settings are correct. I also tried pocketing a simple circle. Finishing its first pass, the cutter repositioned off center, lowered, and began its second cut. The cutting path on screen is showing up correctly in each case. Thanks, Jeff