1
Mach3 and G-Rex / Help getting MACH3 working
« on: October 06, 2011, 12:17:37 AM »
I am having quite a few problems getting my DIY machine operating. I bought it used (nevered actually been used) it is a 2' x3' and it came from Fine Line on the web. Everything did or does power up, I fail the diagnostic test everytime but the MACH3 diagnostic page said my pulse frequency was 24800. The unit does not jog and no table (red outline shows up on the home page). I took some screen shots of the diagnostic test page that show me how bad my Khz were and some images of the Mach3 config page (Ports and Pins etc.). I have uninstalled and reinstalled then uninstalled and rebooted then reinstalled Mach3 and rebooted...still nothing. Does anyone have some sort of idea of where I might check next since I am getting tired of unistalling and reinstalling. I can send images (pdf file) if anyone is interested in helping.