Hello Guest it is June 27, 2019, 01:32:31 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - chippypah

Pages: 1
1
General Mach Discussion / Feed Rate and cutter Speed
« on: September 09, 2010, 04:21:55 PM »
Hi All,
I am new to this so got a few questions, if somebody can help.
What feed rate and spindle spied should be used when cutting acrylic,  I use 5mm and 10mm acrylic.
Cheers
Pete

Pages: 1