Hello Guest it is April 11, 2021, 07:08:16 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - plastics4

Pages: 1
1
General Mach Discussion / Mach3 & Artcam ramping problems
« on: January 31, 2007, 11:02:38 AM »
Has any body got any thoughts on this one...we are looking at using artcam insignia with mach3, The guy from artcam has been over and sorted out the post processor to work with mach3 (forgive me if nothing makes sense from now on as i really havent got a clue whats going on) when the machine goes to cut a simple slot the cutter ramps down into the cut even though all ramping has been switched off, the g code isnt telling it to ramp down, the displays shows that the tool path doesnt ramp down but it still does - well it had both of us scratching our heads !!! ??? ???

Pages: 1