Hello Guest it is December 01, 2021, 02:57:08 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - efebur

Pages: 1
1
General Mach Discussion / Mach 3 and Sheetcam under linux?
« on: October 22, 2012, 06:11:51 PM »
Can I use Mach 3 and Sheetcam on any linux os like mac osx or ubuntu or pardus?

2
General Mach Discussion / Z axis homing problem
« on: October 21, 2012, 01:37:15 PM »
Hello

I am using cnc plasma and router. And that tables have one controll system so drivers pc etc.

I wasn't using my router for a long time. And I need that today. But I have a some problems. I can't found my mach 3 mill folder. And I reset all of settings. I set all of settings but when I press the go to zero button, Z axis doesn't going to zero. Going to up when pressing the limit switch. I loaded the G-code, pressed the cycle start but that didn't go real measurements. Going to smaller than 40 percent draw and drilling that.

So I ll wait replies. What can be wrong? ???

Note: I am sorry for my bad english.  :(

3
Flash Screens / Make a Flash Screen
« on: August 23, 2010, 12:22:34 PM »
I want to make flash screen

But I don't know

how make flash screen and what program use make flash screen

please explain this to me in detail

thanks

Pages: 1