1
LazyCam (Beta) / Post GCode stopt functioning
« on: August 25, 2010, 10:48:25 AM »
Till yesterday, LC was working as it suppose to work. Then last night my virus scanner, started operating as planned in a schedule (every Wednesday morning 2am).
This morning, i created a simple square, 100x160mm and 1mm deep. (i did this before and it worked) i imported the DXF in LC and saved the Lcam project like usual, and then i post it like usual. Only this time nothing append, the tap-file was not made like it usual did.
After repeating the task a few times with no success i used the old one (tap-file) from a few days back, and milled out my square.
Reading on the forum, did not give any solution. so i removed LC, rebooted the pc and reinstalled LC (downloaded from the web) did check the log of the virus scanner, but Nothing happened or was removed. started Mach3, and from within mach3 LC, opened the LCam project, assigned the tools (they where gone) and try to post once more, with no success.
What did i do wrong, or what can i do to post the Gcode again.
Thomass
:-(
This morning, i created a simple square, 100x160mm and 1mm deep. (i did this before and it worked) i imported the DXF in LC and saved the Lcam project like usual, and then i post it like usual. Only this time nothing append, the tap-file was not made like it usual did.
After repeating the task a few times with no success i used the old one (tap-file) from a few days back, and milled out my square.
Reading on the forum, did not give any solution. so i removed LC, rebooted the pc and reinstalled LC (downloaded from the web) did check the log of the virus scanner, but Nothing happened or was removed. started Mach3, and from within mach3 LC, opened the LCam project, assigned the tools (they where gone) and try to post once more, with no success.
What did i do wrong, or what can i do to post the Gcode again.
Thomass
:-(