Hello Guest it is April 26, 2024, 06:23:42 AM
Profile Guest

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - gaanes

Pages: 1
1
General Mach Discussion / Steppers and constant contour under Mach 3?
« on: September 07, 2010, 02:18:12 PM »
I am looking at upgrading my stepper driven system (currently Ahha), does Mach 3 make the steppers constant contour instead of stopping at every line (jerky slower movement) like the old Ahha does? I want to upgrade to Mach 3 so I can run Windows and have a modern computer with networking and a USB port. Also the old Ahha Artisan didn't constant contour very well. Maybe I'm spoiled from our large servo driven system (Fagor).

Pages: 1