1
General Mach Discussion / Problem with feedrates after loading license file - help!
« on: August 09, 2010, 01:07:09 PM »
Hi all, I am new to this forum so HELLO!
My problem is I have had my boxford 240tcl running in demo mode for a while now with no problems.
I loaded my new license file from machsupport today and it all works fine except when using controlled feed rates in feed/rev mode the are now really slow.
If I take the license file out of the mach3 folder it all returns to normal!
I have checked the motor tuning settings and they stay the same, any ideas what could be wrong???
Thanks, Rich
My problem is I have had my boxford 240tcl running in demo mode for a while now with no problems.
I loaded my new license file from machsupport today and it all works fine except when using controlled feed rates in feed/rev mode the are now really slow.
If I take the license file out of the mach3 folder it all returns to normal!
I have checked the motor tuning settings and they stay the same, any ideas what could be wrong???
Thanks, Rich