Hello Guest it is July 10, 2020, 06:59:24 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - hharley

Pages: 1
1
General Mach Discussion / Display mode/Homeing and soft limits question
« on: August 04, 2010, 03:36:30 PM »
when i click deplay mode  i can not see the grren patter to my table...when i watch the video it did everything to MM  and i set my homing and soft limites as such..... But then reallized my software set to inches...so i changed it to inches as follows X 16.    Y 24. and Z -4.   came back to display and hit regenerate  and  dis[lay button..............I get a big  green L shape   with item to cut in lower left corner   but not the shape of my table? i have zoom in and out   no change with the L except big and small?

2
General Mach Discussion / Zoom
« on: August 03, 2010, 09:43:33 PM »
I have read the other post on zooming in on table...Dont work for me ...I hold left mouse  and drag back  and it just turns the picture   Hold right and drag back   and does something elce . How do i zoom in ? if these fail?

3
General Mach Discussion / Motor problem
« on: August 02, 2010, 02:43:40 PM »
I had Mach 3 installed and leaning it. I could move the motors at will and do the examples . I had to reload the Mach 3   and sence then having motor  control problem.    No matter what arrow key i chose . It moves the X  to the left only . I have checked Pin settings and they are correst. Im useing wondows XP . I have reloaded the Mach3 program and LPT driver 3 times   same results

Pages: 1