1
General Mach Discussion / Mach3 driver doesn't restart after WinXP wakes up from sleep mode
« on: September 16, 2011, 01:51:31 PM »
Hi. I stupidly posted this question before with the subject Driver gets lost, leading some to believe I was posting a joke or a tale about my wife's driving,
What I meant is why does the Mach3 driver refuse to wake up? I put a shortcut on my desktop to the system properties, where I can find the Mach3 driver under
the device manager. From there you can right click - disable, and then right click- enable. This works, but is a pita. I want to be able to leave sleep mode active,
as I'm often doing other things while the machine is milling.
Anyway, thanks for any advice.
What I meant is why does the Mach3 driver refuse to wake up? I put a shortcut on my desktop to the system properties, where I can find the Mach3 driver under
the device manager. From there you can right click - disable, and then right click- enable. This works, but is a pita. I want to be able to leave sleep mode active,
as I'm often doing other things while the machine is milling.
Anyway, thanks for any advice.