Topics

1

General Mach Discussion / CamBam export g code into Mach3

« on: June 02, 2012, 09:43:32 PM »

I have searched a lot, here is my results. I am trying to machine a  3D object, drawn in Viacad. STL import into CamBam, toolpathed and g code are done. This is where I get lost. It seems Lazycam only imports/exports 2 and 2.5 dxf drawing into Mach3. Lazycam is the only way to get a drawing into Mach3. However, Can I export/import my 3d drawings  g-code from CamBam  into Mach3? Am I limited in Mach3 usage in doing so? I am going through everything  (tutorials) and the manual again, as I am still new, but am asking this as a course of direction so as not to waste time and energy. Thank you, Robert

2

Forum suggestions and report forum problems. / Search not working.

« on: June 02, 2012, 08:16:49 PM »

When searching for dxf or export, I get an error message, it says error, if this happens again, contact admin