Hello Guest it is March 29, 2024, 08:18:23 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - cncobsession

Pages: 1
1
General Mach Discussion / g code will not load completely on tool screen
« on: August 07, 2010, 01:47:29 AM »
I have designed three gears in Cambam and tested them in cutviewer.  Everything runs fine.  When I load it into Mach 3 theg code appears to load but only about 2/3 of one of the gears loads and appears on the screen.  I am lost.  Could it be a memory problem on the computer?

Help please!

Morgan

Pages: 1