Topics

1

General Mach Discussion / Slow into hard corner?

« on: August 03, 2010, 12:44:34 PM »

I think I may be needing to configure my CV settings, but I am not entirely sure.  Basically, I have a square drawn that I want to cut out with sharp corners.  At present I am achieving the sharp corners but the machine seems to feed into the corner, hardstop, move off perpendicularly.  This seems unnecessarily abrupt and I was thinking it might be nice if I could get mach to decelerate into the corner gradually before moving off perpendicular. 

Is this possible?  or simply a foolhardy idea?

Thanks much
Brian