Hello Guest it is March 29, 2024, 06:17:10 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - sped1530

Pages: 1
1
General Mach Discussion / motor input missed up
« on: December 20, 2012, 06:02:16 PM »
I tried to fix my mach3 but screwed it up now it's cutting letters in reverse.  

2
General Mach Discussion / z not raising enough after cutting
« on: October 12, 2011, 11:49:48 AM »
I set my vcarve  to .3 and my mach3 safe z to .2 . It cuts the letter then move to the next letter and carves a .05 grove as it move to the next cut. 

Anyone ever have that problem?

Dave

Pages: 1