Guest
Show Posts
1
dspMC/IP Motion Controller / dspmc with mach3 - output problem
« on: July 20, 2010, 05:03:11 AM »
Hi!
I have problem with otput0(on the board pin0). When starting axisworks i can control 16 outputs without any problem. When I run mach3 with dspmc plugin, push reset button the output0 goes high. It's strange because i dont have any output assigned in "Port and Pins". It looks like mach3 control this output but i cant find how.
Can you help?
I have problem with otput0(on the board pin0). When starting axisworks i can control 16 outputs without any problem. When I run mach3 with dspmc plugin, push reset button the output0 goes high. It's strange because i dont have any output assigned in "Port and Pins". It looks like mach3 control this output but i cant find how.
Can you help?