Hello Guest it is March 29, 2024, 10:10:23 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - forrestcarve

Pages: 1
1
General Mach Discussion / Will only run part of G-code program
« on: March 03, 2011, 10:27:24 AM »
I am new to cnc and for the past year have been trying to get this machine to run. Thanks to this forum, I seem to making some progress. My problem right now is any program that I transfer from V-Carve will start and run fine, "up to 500 lines of G-Code "and then stops. I know that my programs are Ok
 in V-Carve, because I have loaded Vectrics free trail "Bulls Head program "and it does the same. 500 lines of G-Code and then stops.
Could there be a wrong setting in the Mach 3 configuration? Any help would be appreicated.

2
General Mach Discussion / Mach 3- nesting comment alert-help
« on: March 01, 2011, 11:56:25 AM »
I am new to CNC. Have had a MAXNC router for about a year now and can't get it running.  The manufacturer has gone out of business, so I can't get any help there.
The problem I am having right now is when I transfer a program from V Carve Pro to Mach 3, the G code loads OK. But when I attempt to run it I get an alert down by the reset button that says "NESTING COMMENT FOUND LINE 1" and the program will not run.
Everything in V Carve pro seems to be fine.
Have never been able to get this #*^# thing to run and am hoping that some kind sole out there can help me. Any comments on this problem would be greatly appriciated.

Forrestcarve

Pages: 1