1
General Mach Discussion / Mach 3 & C10 breakout spindle control?
« on: June 22, 2010, 03:53:48 AM »
Hello I'm new to this and need some training wheel help please!
I'm using M3 with a C10 breakout and id like to know how i could control the speed of my spindle, the only info i have on the spindle speed controller is on the link below which has a diagram (and its in Japanese). Will the C10 do a variable Voltage/Current? into the VS,VC or CC inputs?. Also how come i cant ramp my spindle speed up past 8000rpm (not that it matters at the moment)
I can turn the spindle on and off but i have no speed controll, if any one could help that would be great and much appreciated.
http://www.lingnangroup.com/ProductInfo.aspx?ProductID=229&LevelCode=00101001
Thanks
D
I'm using M3 with a C10 breakout and id like to know how i could control the speed of my spindle, the only info i have on the spindle speed controller is on the link below which has a diagram (and its in Japanese). Will the C10 do a variable Voltage/Current? into the VS,VC or CC inputs?. Also how come i cant ramp my spindle speed up past 8000rpm (not that it matters at the moment)
I can turn the spindle on and off but i have no speed controll, if any one could help that would be great and much appreciated.
http://www.lingnangroup.com/ProductInfo.aspx?ProductID=229&LevelCode=00101001
Thanks
D