Topics

1

Mach3 under Vista / Mach3, Windows 7, XP Mode

« on: June 17, 2010, 02:43:59 PM »

First, thanks for everyones knowledge and help in this forum. I have gone about this install on a windows 7 machine in the manner that has been described in many of these posts (through windows xp mode). The driver test passes with an excellent mark, and Mach 3 opens up. But there is no motion when a signal is given from mach 3 to the cnc. I have all outputs enabled, and the correct port # set in config for the parallel port. Any Ideas? Thanks!