Guest
Show Posts
1
General Mach Discussion / 3d probing not working
« on: January 26, 2007, 12:12:08 AM »
Hi,
I'm new to cncs, and am having trouble with the 3d probing plugin in mach3. I get all the way to the press probe tip to test, and when I touch it, the reset goes off. If I bypass that step, and press start sequence operation, I get a no probe message. This is on a Taig cnc with their controller. It works with their software, but it's written in dos, and won't allow me to write on anything but the floppy that the program boots up from.
Can anyone help?
John
I'm new to cncs, and am having trouble with the 3d probing plugin in mach3. I get all the way to the press probe tip to test, and when I touch it, the reset goes off. If I bypass that step, and press start sequence operation, I get a no probe message. This is on a Taig cnc with their controller. It works with their software, but it's written in dos, and won't allow me to write on anything but the floppy that the program boots up from.
Can anyone help?
John