Guest
Show Posts
1
Third party software and hardware support forums. / Mach3 plus xylotex wiring
« on: January 25, 2007, 07:55:28 PM »
I have Mach3 running a Taig Mill.
I am using a Xylotex 4 axis driver setup.
I have 5 NC Micro Switches that I need to wire to the driver board. I have seen a bunch of information on doing this in series, but cannot find how to do this correctly with each individual switch setting off the X++, X--, Y++, Y--, and Z++ in Mach3. I need to use the board inputs for pins 10-14 (right?) but how do I wire these up specifically?
I'm sure this question has been asked before, but I cannot find the answer anywhere in these forums, and there is no applicable diagram at the xylotex site.
Thanks in advance for your help!
I am using a Xylotex 4 axis driver setup.
I have 5 NC Micro Switches that I need to wire to the driver board. I have seen a bunch of information on doing this in series, but cannot find how to do this correctly with each individual switch setting off the X++, X--, Y++, Y--, and Z++ in Mach3. I need to use the board inputs for pins 10-14 (right?) but how do I wire these up specifically?
I'm sure this question has been asked before, but I cannot find the answer anywhere in these forums, and there is no applicable diagram at the xylotex site.
Thanks in advance for your help!