Topics

1

General Mach Discussion / Macro Functions, Mach loads them while loading Gcode ?

« on: August 12, 2010, 08:48:47 AM »

Hello,

I'have written a macro function where mach slouild wait before going to the next gcode.

When loading a Gcode file where in the middle stands the M code ( M32 )
Mach Keeps waiting till the input is active...
This schouild be only on cycle start,  not on loading a gcode file....

Is is possible to do an if / statement in the macro what checks the status of cycle start ?

Thanks  Ronald

2

Brains Development / Laser Modulation Output

« on: August 03, 2010, 03:49:11 AM »

Hello,

We're Converting an old Bystronic Lasermachine ( Co2 laser 1500 W ) To Mach 3,
Using the DSPMC To run the Old analog servodrives.

I've programmed a script in Bains that will modulate the laserbeam when the machine stops working.
When the actual speed < the requested speed.
I need id otherwise the machine cannot cut fine RVS or steel.

Is it possible to make some G or M codes to modulate an output ?
I've Also cutting gas control via an proportional valve.

The dspmc have 8 analog outputs,  Just 2 using for the axes.

Can i make an M code  and write a variable to an analog port ?

Thanks  Ronald.

I'll make some movies when everything starts to work.