Topics

1

General Mach Discussion / engraver control

« on: June 07, 2010, 01:09:47 PM »

OK I'm a noob to this and was wondering if anyone could help me out or point me in the right direction. i have installed a platemarker onto my bladerunner AIO controller. i am able to manually turn the plate marker on by clicking the output #2 button on the mach ubobIII screen. now my question is how do i get the plate marker to turn on and off for a g-code that's loaded. then switch back to plasma cutting within the same code. i have looked in all the manuals that i can find but I'm either looking in the wrong spot or i dont have that manual. i  am running mp1000-dthc-scriber as my post processor to do the plasma cutting and engraving.

any help with figuring this out or pointing me in the right direction would be greatly appreciated

thanks