Hello Guest it is May 31, 2023, 06:23:35 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - Csabika

Pages: 1
VB and the development of wizards / Y, U, V Change X DRO
« on: June 22, 2010, 04:45:26 PM »

how macro to be any axis in g code the x-axis move?
If G code Y300 you move X-axis 300
              U300 you move X-axis 300


VB and the development of wizards / mach3 and beam saw
« on: May 23, 2010, 04:17:41 PM »

Make old machine control exchange on a saw, Mach3 controls it and DSPMC - Ethernet Motion Controller
The problem:
a macro would be needed what does a process if it is X the value of an axis smaller than 150 mm ,
so X let an axis go onto a size there let him wait give one M9 code, and let him go to the back 200mm
I tried to do it, but since 0 are his starting values x axis, the mach does nothing at the time of a departure

Regards Csaba

Pages: 1