Hello Guest it is November 22, 2019, 10:41:03 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Boethius

Pages: 1
1
G-Code, CAD, and CAM discussions / G code Sub routine
« on: May 20, 2010, 06:17:52 PM »
Hi everybody. i don't know if it's the right place but i need some help with G-Code. I want to make a code that, for example, drill in one place and then drill again 20 microns to the side and then 20 micron again until it reach 3 mm. Basically i need to make a code with incremental of 20 micron to the side and then down, left and up again to make a square. I a simple thing but i try over and over again and i can't do it.

Thank you

Pages: 1