Hello Guest it is March 28, 2024, 09:07:42 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - johnchristensen

Pages: 1
1
General Mach Discussion / rounded off corners
« on: May 07, 2011, 01:20:51 AM »
I have some issues with rounded off corners.  It doesn't seem to matter whether they are internal or external.  I read through the forums and someone mentioned during on some angle thing.  (something to do with 89 degrees)  I can't seem to find it right now, but I did so and I though that solved the issue.  However it popped up again and cut some corners that I didn't intend of having cut. 

Ideas?

Pages: 1