Guest
Show Posts
1
Mach3 under Vista / new Pc + Vista --> frequency variations in stepper
« on: May 16, 2010, 05:10:14 AM »
Hi,
I have a problem with my cnc machine. After two Ide Hdd had broken under my old Fujitsu Scenic Pc I decided to exchange the old Fujitsu mainboard with a new Elitegroup mainboard with dual core cpu. As i wasn't able to install xp on this mainboard I had to install windows Vista. I have already read the Vista Readme from the Mach3 Homepage and installed everything as described. Nevertheless the machine isn't running fine, as there a short, continuous variation in the frequency in the stepper (you can hear this). Under xp in combination with the old Fujitsu mainbaord everything went fine.
Now I'm not sure if the mainboard or Vista is responsible for this mistake.
Do you have any advice?
With best regards from Germany and thx for your help in advance
Step-walk
I have a problem with my cnc machine. After two Ide Hdd had broken under my old Fujitsu Scenic Pc I decided to exchange the old Fujitsu mainboard with a new Elitegroup mainboard with dual core cpu. As i wasn't able to install xp on this mainboard I had to install windows Vista. I have already read the Vista Readme from the Mach3 Homepage and installed everything as described. Nevertheless the machine isn't running fine, as there a short, continuous variation in the frequency in the stepper (you can hear this). Under xp in combination with the old Fujitsu mainbaord everything went fine.
Now I'm not sure if the mainboard or Vista is responsible for this mistake.
Do you have any advice?
With best regards from Germany and thx for your help in advance
Step-walk