1
General Mach Discussion / Proximity Sensors Setup
« on: May 16, 2010, 12:49:27 AM »
Hi everybody.
I'm new to forum as well in Mach3.
I have just finished my CNC machine in which i have installed 4 proximity sensors, 2 for X, 1 for Y,Z axes.
What i can't figure out yet is how to set up my sensors in Mach3.
I have them all attached to pin 11 port 1.
All suggestions welcome.
Thanks
Sergio.
I'm new to forum as well in Mach3.
I have just finished my CNC machine in which i have installed 4 proximity sensors, 2 for X, 1 for Y,Z axes.
What i can't figure out yet is how to set up my sensors in Mach3.
I have them all attached to pin 11 port 1.
All suggestions welcome.
Thanks
Sergio.