Hello Guest it is March 28, 2024, 06:26:43 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - mecanicu

Pages: 1
1
Hello
I have 3 Tamagawa AU6550N2062 DRIVER ser. no. 20716 with 3 Tamagawa TBL-i series AC Servo Motor TS4513N1820E200 600W 200v S/NA14253, with all the cables. I attached the manual for them.
Need to set them so they can work with step/direction signal's from mach3.
I don't know exactly what i did wrong but the motor is turning half a revolution only in one direction and it's go offline.
I set the step to - forward pulse and the dir to - reverse pulse. The + forward pulse, + reverse pulse signal ar wired together to +5v com pin to the breakout board (c23 multifunctional board from cnc4pc). Maybe i need to set some parameters in the driver, but i don't have the paramater table for it(tha manual only mention about parameter's ???).


http://www.hwadong.biz/pdf/1525n4e.pdf



Pages: 1