1
General Mach Discussion / loss of control
« on: May 12, 2010, 06:36:24 PM »
I installed Mach3, ran through the conconfiguration to get it set up and everything worked great. Then I loaded Bobcad into the computor. I designed a part, converted it to gcode and tried to start the mill when I found out that it no longer worked. The X Y &Z all seem to be loaded in the same port. the X axis goes in the same direction regardless if I manually press left or right, the y axis only works when I press the Z key.
Did the computor reconfigure itself? Help!!!
Did the computor reconfigure itself? Help!!!