1
General Mach Discussion / Mach3 GCode line limit
« on: June 25, 2011, 03:17:09 PM »
Hi there.
I've been using the 3.042 Mach3 trial version for a long time now and only today I noticed that I can not run more than 150 lines of Gcode.
I know that for the trial version the line limit is set to 500 lines!
This happens in Mach3Turn as far as I know because I didn't try the Mill version yet (I mean with a part code over the 150 lines).
My setup is Windows XP SP3 and KeyGrabber.
Can someone tell me where I go wrong?
Thanks in advance.
Alberto
I've been using the 3.042 Mach3 trial version for a long time now and only today I noticed that I can not run more than 150 lines of Gcode.
I know that for the trial version the line limit is set to 500 lines!
This happens in Mach3Turn as far as I know because I didn't try the Mill version yet (I mean with a part code over the 150 lines).
My setup is Windows XP SP3 and KeyGrabber.
Can someone tell me where I go wrong?
Thanks in advance.
Alberto