Guest
Show Posts
1
General Mach Discussion / Program home
« on: May 06, 2010, 09:47:56 AM »
Hey,
I hope someone will know this. Is there a program home on the Mach 3? After running the program I need to move the head out of the way so that I can put up a new part. If I hit refer all home it goes home but when I hit run it doesn’t go back to the part. Is there a way to do this without manually going back to my program starting point? On my water jet I just hit goto “program 0”
Thanks Jeff
I hope someone will know this. Is there a program home on the Mach 3? After running the program I need to move the head out of the way so that I can put up a new part. If I hit refer all home it goes home but when I hit run it doesn’t go back to the part. Is there a way to do this without manually going back to my program starting point? On my water jet I just hit goto “program 0”
Thanks Jeff