1
General Mach Discussion / Ref Z-axis
« on: May 02, 2010, 04:39:39 PM »
Hello,
I have a problem with referencing the z-axis of my plasma table. When I push the ref-all button the X and Y axis are referencing well, but the Z-axis does not move at all. When I push the ref-Z button in the settings screen it works well. Why does the Z-Axis not ref. with the ref-all command. Any help is welcome.
Regards,
Remco
I have a problem with referencing the z-axis of my plasma table. When I push the ref-all button the X and Y axis are referencing well, but the Z-axis does not move at all. When I push the ref-Z button in the settings screen it works well. Why does the Z-Axis not ref. with the ref-all command. Any help is welcome.
Regards,
Remco