Hello Guest it is March 28, 2024, 09:42:52 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - travislivid

Pages: 1
1
General Mach Discussion / Problem with creeping motor sitting still
« on: April 27, 2010, 10:44:24 PM »
I have a 3 axis machine. On just the y axis if the machine is sitting still with the control box and computer running I get a little bump every few minutes in the y axis motor. It acccumulates to 1/4" of movement in about 45 min all by itself. Mach3 thinks it is still at home. This occurs even when mach is not running but will stop when I unplug the serial cable to the control box. Any Ideas?

Pages: 1