Hello Guest it is December 01, 2021, 01:44:28 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - kris10x

Pages: 1
1
General Mach Discussion / Jerky movement
« on: June 01, 2010, 05:48:09 PM »
   Hello,
I have a problem with machine controlled by Mach3 software. When you run a NC file, the movement of the machine along a curve is jerky. On the straight lines is smooth. The NC file was generated from ArtCAM. I tried postprocessors for arcs and for straight lines, but the result is identical. The attached is a sample NC files and screenshot of motor tuning (everything is in millimeters.).

    Would you help me solve this problem?

2
General Mach Discussion / spindle does not rotate
« on: April 27, 2010, 06:33:01 AM »
   Hello,
I have a problem with the spindle of a machine run by Mach3 software. Version is 3042039. Spindle is managed by the relay contact. In menu "Port & Pins / Output Signals" - Output # 1 is set to Port1/Pin17. I tried all the free pins, but without success - by pushing the button "Spindle CW F5" yellow frame around the button flashes, in the tab "Diagnostics Alt-7" red box "Output1" also flashes, but the spindle does not rotate. The connection of the spindle to its controller is correct,  I can run it manually and it rotates. In the website of ArtSoft/Downloads/Mach3 Changelog saw that it was a problem in a slightly older version of the software "Jan 05/2010 Release 3.042.034 -- Spindle not turning on bug fixed".

Would you help me?

Pages: 1