Guest
Show Posts
1
LazyCam (Beta) / Opening LC in plasma mode
« on: June 23, 2010, 01:42:22 AM »
Hello,
I am using LazyCAM to convert DXF's in plasma mode. I make some mods in LC and save
the project as a .lcam file. If I exit LC and come back to it when I open the .lcam project
is defaults to mill mode. I can work around this by opening dxf in plasma, closing then
opening .lcam file but it is a pain.
Any comments/advice?
mike
I am using LazyCAM to convert DXF's in plasma mode. I make some mods in LC and save
the project as a .lcam file. If I exit LC and come back to it when I open the .lcam project
is defaults to mill mode. I can work around this by opening dxf in plasma, closing then
opening .lcam file but it is a pain.
Any comments/advice?
mike