Topics

1

PoKeys / Led's on control panel

« on: September 09, 2010, 09:42:30 AM »

Hi All
I’ve been away from the cnc world for a little while, And now trying to catch up.
I’m making a new control panel and wont to put led’s on it to show the state of different things,
Now I don’t want to draw too much power from the pokey’s so I’m making this circuit to use external power For the led’s, but I’m not too good at electronic can someone tell me if this will work? There may be 6 to 8 led’s on at the same time.
Also thanks to Borisz and Scott, this little device works grate, and a special thanks to Scott for his service to this Country.
Gary

2

Show"N"Tell ( What you have made with your CNC machine.) / “Touch Probe” I think I made a good one

« on: August 02, 2007, 04:23:18 PM »

I had a problem using my tool height touch off and my probe
My height touch off was active low, a peace of urethane with a peace of aluminum glue to it.
But the probe was active high, to use both I had to go in to ports&pin and change it back and forth, not well
 
So I come up with this probe (active low)
It can repeat at .0006
Out of round .0009
For me, that good enough.
It can be made (active high) to, the over all length is 5” but I think I can cut that back to 4”
This was just the prototype, just two hours to make it and that’s with a design change in
Mid stream.

Gary

3

Show"N"Tell ( What you have made with your CNC machine.) / Throttle body spacer

« on: June 04, 2007, 02:03:53 PM »

My son was going to buy a throttle body spacer for his truck $90.00
I said let’s make one, so here we go
After we made the spacer we could not find the bolts
I said let’s make two, so here we go.

6x6x1 3/8 aluminum, found in scrape = 0
5/8 rod for bolts, found in scrape = 0
Time spent working with my Son = Priceless 
 
Three in one converted to cnc using mach3
Thanks Art for making this possible

Gary