1
General Mach Discussion / Having M3 output as pulse
« on: October 17, 2011, 04:17:19 PM »
Good morning,
For my dot peen engraving applicationi use M10p1 and m11p1 commands to turn on and off the marking head.
Is it possible to have the output of M11p1 as pulses that i can set the frequence(100 hz.)
(I use m10 and m11 instead of M3 and 5 because they react faster)
Cemal
For my dot peen engraving applicationi use M10p1 and m11p1 commands to turn on and off the marking head.
Is it possible to have the output of M11p1 as pulses that i can set the frequence(100 hz.)
(I use m10 and m11 instead of M3 and 5 because they react faster)
Cemal