Topics

1

General Mach Discussion / Conversion of Denford TRIAC milling to LPT

« on: July 15, 2012, 07:22:43 AM »

Hello everybody, I bought an old non-used TRIAC milling machine (the green one), and I want to convert it to work with MACH3.
I read almost all of the Posts that talk about this, but I didn't find any clarifications or descriptions on how to convert it.
I have in the attached file the Pin Configurations for the input cable to the controller of this machine.
I want your help in connecting this cable with the breakout board in order to work on MACH3.
Thanks in advance.

Usama

2

G-Code, CAD, and CAM discussions / Total lines in the G Code for each file ??

« on: February 29, 2012, 11:43:56 AM »

Hello

I would like to know if there is a Gcode or macro to give me the total numbers of the lines for each file I open in mach3 ??
In other words, I want a dro or input to show me the total lines for the file in the mach3 page.

Regards,
U.H