Guest
Show Posts
1
General Mach Discussion / A Axis Setting rotary motion
« on: April 16, 2010, 01:57:11 PM »
Hi,
I just installed a 4th axis on my Tormach and it appears that the setting for the A axis is presently for linear motion. I understand it can be changed to rotary motion in the configuration. However, I can't find where to do this.
Any advise would be greatly appreciated. Please be specific with step by step instructions.
Thanks
Jorg
I just installed a 4th axis on my Tormach and it appears that the setting for the A axis is presently for linear motion. I understand it can be changed to rotary motion in the configuration. However, I can't find where to do this.
Any advise would be greatly appreciated. Please be specific with step by step instructions.
Thanks
Jorg