1
General Mach Discussion / Y axis help
« on: March 25, 2012, 12:28:14 AM »
I have a 24 X 48 mill with a safe working area of 22 X 44, what I am trying to do it to start my cuts at 11 inches on the Y axis to make it easier to cut 2 sided files, I would like to set the home at 11 inches on the Y axis but am unsure how to set mach up to do this.
This way i can mark the center of the piece i am cutting and can just flip it over to do the backside.
Any help would be appreciated
This way i can mark the center of the piece i am cutting and can just flip it over to do the backside.
Any help would be appreciated