Hello Guest it is May 17, 2021, 12:44:34 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - pmesilver

Pages: 1
1
General Mach Discussion / circular interpolation
« on: April 10, 2010, 05:29:45 AM »
can anyone confirm that mach 3 will recognise the K variable in a G02 or G03 command when machining curves that run on XZ or YZ plane? Also when used in conjuction with G18 G19

the controller on my machine unfortunately will not, so i am considering converting to mach 3!

many thanks

Pages: 1