1
General Mach Discussion / Homing problem on router with 2 steppers on Y axis
« on: July 29, 2008, 05:38:59 PM »
Hello, I am running version 2.61 and trying to set up homing...
In the past all I used were the limit switches as safety stops, but would like
to get the homing set up.
I watched the Vidio Tutorial on Limits/Homing and have set things up per that advise,
however when it starts to home the Y axis, the steppers on opposite sides of the
gantry move in opposite directions.
Everything work just fine when in MPG Mode or running a Gcode file...
What have I forgotten to check or uncheck in the limits/home area that is causing
the Y steppers to run in opposite directions just when homing?
Thanks in Advance,
Preston
In the past all I used were the limit switches as safety stops, but would like
to get the homing set up.
I watched the Vidio Tutorial on Limits/Homing and have set things up per that advise,
however when it starts to home the Y axis, the steppers on opposite sides of the
gantry move in opposite directions.
Everything work just fine when in MPG Mode or running a Gcode file...
What have I forgotten to check or uncheck in the limits/home area that is causing
the Y steppers to run in opposite directions just when homing?
Thanks in Advance,
Preston